If that isn't the problem, check the electrical plug underneath the heated seat where the seat plugs into the main wiring harness. When the etc or check engine lights come on it's because a fault code has set.
Also worst case, you might have to change the rear heater core.
Why isn't my heat working in my dodge journey. The first thing you would need to do is have the fault codes read. If it’s not coming on at all, it’s usually either the blower motor or some other wiring issue. I figured out that the one thing that made it work was when i.
If the thermostat can’t signal to the car that the engine is warm, the coolant won’t be sent over to provide heat. It will stop after about 10 seconds. At the simplest level, there are two main reasons why the heater is not working.
The most common reasons a dodge journey heater isn't working are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor. Clicking noise from dash on paasenger side. Chrystina answered about a year ago.
Dodge journey 2013 model has more than one problem that exhibit key not detected message. I hot wired the pump and it came on so now i have to trace the wires back and find out why the controls are not sending power. Heat works on the driver side but not on the passenger side.
Changed the heater core, checked all the actuators, even manually moved the blend door mechanically to full hot still no heat on the passenger side. We had it flushed out, new thermostat, and finally a new heater core. The blend door itself does not seem to be broken when i move the doors manually.
If you notice that your thermostat gauge stays on the “c” even after the engine has time to heat up, you may have a broken thermostat. I have the same problem took all the plastic out and fixed my broken mixer door. My dodge journey would blow hot air on the driver side and lukewarm air on the passenger side.
I figured out that the one thing that made it work was when i. Push in and hold the volume and the tune button at the same time. Still poor heat in the rear them i found the pump was not getting power.
Changed the heater core, checked all the actuators, even manually moved the blend door mechanically to full hot still no heat on the passenger side. Because you didn’t mention having an issue with the a/c, the problem is more than likely related to a. Heat works on the driver side but not on the passenger side.
Hold for about 10 seconds or until the screen goes black. We still don’t have sufficient heat it is like semi warm both sides. What else can we check?
This can be done with a scan tool or code reader, most parts stores will do it for free. If a fuse is blown, replace it immediately. Bluedevil proon february 19, 2021 at 8:59 am.
The blend door itself does not seem to be broken when i move the doors manually. You can verify this by checking the coolant level by taking a peek at the overflow reservoir. Posted on may 17, 2015.
Is there isn’t enough line pressure, due to low coolant, then the heater core will not be able to get any coolant itself. While not having enough coolant may make your engine run hotter, it can also cause your journey to not be able to create enough heat. After investigating the issue for about a month i have come to the realization that the computer in the dodge journey's is actually pretty clever if not.
When you begin the troubleshooting process, the first thing you should do is inspect the fuses. Clicking coming from passenger side of dash when unlocked or door opened. I could not figure out why my heat wouldn't come on in the rear vents of my 2013 dodge journey sxt and although i hit rear climate and sync on my screen.
Chrystina answered about a year ago. Found out that cold air was coming out of the passenger side of car. If the engine is only running hot when the a/c is on, it could be due to a failing a/c compressor.
Go to a dealer for warranty work. I could not figure out why my heat wouldn't come on in the rear vents of my 2013 dodge journey sxt and although i hit rear climate and sync on my screen. Hello and welcome to justanswer!
I had it towed to a dodge dealership and they charged me $800 to. The heater hose on my 2010 dodge journey failed without warning and left me stranded on the side of the road. If the heat is blowing, but blowing cold, it has something to do with the coolant getting to the heater core, or the heater core itself.
Pressing the switch a third time will shut the heating elements off. A problem in your heating system can usually be traced to one or more of the systems that produce and distribute the heat to the interior of the vehicle. To reboot the uconnect perform the following steps:
Indicator lamps illuminate for each heated seat switch and indicate the level of heat in use (hi or lo). 31% of the time it's Dodge journey has heat on drivers side and cold on passenger and rear.
Reasons your heating system isn't working. I have a 2011 dodge journey sxt. Just purchased a 2010 dodge journey.
Heat only on drivers side, luke warm to cold air on passenger side and in rear.